Middleby CROWN GSX-10HE, Installation & Operation Manual

Page: 6 / 20

INSTALLATION & OPERATION MANUAL 10124 REV 0 (03/21) PAGE
6
OF 20
G as F ired S teamers
To Install
1. Uncrate carefully. Report any freight damage to the freight company immediately.
2. Set the unit in place. Be certain to maintain the minimum clearances from combustibles and non-combustibles.
3. For an appliance supplied with legs, level the appliance using a spirit level. Should flanged adjustable feet be
provided, anchor to floor using proper anchoring devices.
4. Seal bolts and flanged feet with Silastic or other equivalent compound.
5. Be certain to leave adequate clearances for cleaning, maintenance and service.
I
NSTALLATION
WARNING
These procedures must be followed by qualified personnel or warranty will be voided. An open gap floor drain is
required immediately below the appliance drain.
WARNING
For an appliance equipped with casters, the installation shall be made with a connector that complies with the
standard for connectors for moveable gas appliances, ANSI Z21.69-CSA 6.16 and a quick-disconnect device that
complies with the standard for quickdisconnect devices for use with gas fuel, ANSI Z21.41-CSA 6.9;
adequate means must be provided to limit the movement of the appliance without depending on the connector
and the quickdisconnect device or its associated piping to limit the appliance movement; the location where the
restraining means may be attached to the appliance is on bottom of unit directly below relief valve.
If the unit is also equipped with an optional water fill valve it too must be installed with a flexible water supply tube,
a quick disconnect and strain relief.
C learances
Adequate clearance must be provided in aisle and at the side and back. Adequate clearances for air openings into the
combustion chamber must be provided, as well as for serviceability for use on noncombustible floors. Minimum clearance
from combustible and noncombustible construction, 0” on left side, 0” on right side and 6” from back.