Middleby Marshall PS360G Gas, Owner'S Operating And Installation Manual

Page: 18 / 42

13
D. Conveyor Installation
1. Unfold the conveyor as shown in Figure 2-12. Then
begin to slide the conveyor into the end of the oven.
The conveyor can only be installed form the side of the
oven where the drive motors are located.
2. Continue moving the conveyor into the oven until the
frame protrudes equally from each end of the oven.
Check that the crumb tray supports located on the
underside of the conveyor frame rests firmly against
the lower end plugs, as shown in Figure 2-13.
3. When the conveyor is positioned properly, check for
freedom of movement of the conveyor belt by pulling it
for about 2 to 3 feet (0.6- 1.0 m) with your fingers. The
drive and idler shafts must rotate smoothly, and the
belt must move freely without rubbing on the inside of
the oven. If not, then re-align the belting.
4.
Check the Tension of the conveyor belt as shown in
Figure 2-14. The belt should lift about 1” (25mm).
DO
NOT OVER TIGHTEN THE CONVEYOR BELT.
NOTE:
If necessary, the belt tension can be adjusted
by turning the conveyor adjustment screws, located at
the ider (non-control) end of the conveyor. See Figure
2-14.
Figure 2-12. Conveyor Installation
Figure 2-14. Conveyor Belt Tension
Figure 2-13