• Use power driver and #2 Phillips bit or #2
Phillips screwdriver and a flat head screw (G)
to secure each power mounting clip (H) to
the bracket holes on the bottom of the frame.
(
FIGURE A
)
NOTE
: Set power strip (J) aside and only
install after the woodkit is attached to the
frame.
For more information, refer to the C3 Series
WoodKit instruction sheet (100-00040).
INSTALLING THE POWER STRIP MOUNTING CLIPS INSIDE THE FRAME
NOTE
:
• Consider power receptacles on the wall and power requirements when deciding which bay (for
non-1-bay models) to install your power strip.
• If using power driver, verify the torque is on the lightest setting and only increase as necessary.
Bracket
Holes
H
G
FIGURE A
Page 6
INSTALLING THE SLIDE-OUT RACK OPTION (C3-TECHKIT4-SO)
TIP
: After installing the slide-out rack option, you can remove the rack from the sliders, dress your rack
on a close bench or table, and then re-attach your rack onto the sliders. Remove the slide-out rack from
the sliders using the first step in “Installing Lever Lock™ Option (LLOCKSWRF-KIT) Inside Slide-Out
Rack Option” on page 9.
1. Set power strip (J) aside and only install after the woodkit is attached to the frame. For more
information, refer to the C3 Series WoodKit instruction sheet (100-00040).
2. Hook the shovel lances on the brackets of the partially pre-assembled slide-out rack (A) into the
rectangular set of holes on the frame (shaded) as shown. (
FIGURE B
)
FIGURE B
A
Rectangular holes on
the frame for attaching
the brackets.
Shovel lances
on back of rack
brackets.
