Chapter 3: Using the Web Interface
85
3.
Configure settings as follows:
Field
Description
Speed
Select a LAN speed.
•
Auto: System determines the optimum LAN speed through auto-negotiation.
•
10 MBit/s: Speed is always 10 Mbps.
•
100 MBit/s: Speed is always 100 Mbps.
Duplex
Select a duplex mode.
•
Auto: The PDU selects the optimum transmission mode through auto-negotiation.
•
Full: Data is transmitted in both directions simultaneously.
•
Half: Data is transmitted in one direction (to or from the PDU) at a time.
Current State
Show the LAN's current status, including the current speed and duplex mode.
Note: Auto-negotiation is disabled after setting both the speed and duplex settings of the PDU to NON-Auto values, which
may result in a duplex mismatch.
4.
Configure IPv4 settings as follows:
a.
Select the Enable IPv4 checkbox to enable the interface. This checkbox is selected by default.
b.
In the IP Auto Configuration drop-down select DHCP or Static and provide the following additional information:
If you selected DHCP, enter a Preferred Hostname in the text box provided.
DHCP hostnames must meet the following requirements:
−
Consists of alphanumeric characters and/or hyphens
−
Cannot begin or end with a hyphen
−
Cannot contain more than 63 characters
−
Cannot contain punctuation marks, spaces, and other symbols
If you selected Static, enter a valid IPv4 address in the text box provided.
If you selected Static, enter a corresponding subnet mask or prefix length for your IPv4 address in the text box
provided.
−
Subnet Mask Example: 255.255.255.254
OR
−
Prefix Length Example: /23
