8 |
I n s t a l l a t i o n a n d u s e r m a n u a l
HEA
T
PU
M
P
M
IC
R
O
W
E
LL
H
P
C
O
M
P
A
C
T
4. HEAT PUMP INSTALLATION AND CONNECTION
4.1 Positioning
The heat pump is designed for outdoor istallation. It will work well in any kind of outdoor
environment, where the following 3 requests are satisfied:
1. Fresh air – 2. Current – 3. Pipe with swimming pool filtration
a)
Do not install the heat pump in closed spaces with limited air
access and where the air can not circulate sufficiently.The air
inlet and outlet must be completely free. No articles must be
placed into the working area of the heat pump (see picture). Do
not put the heat pump near bushes or trees either,as these can
also influence the air access. Every single barrier of free air flow
reduces the efficiency of the heat exchange and can lead to the
heat pump shut down.
b)
The heat pump must not be exposed to direct sunlight. It should
be protected from other heat sources as well. The optimal
location is where the heat pump is able to suck in the air from the sunny surrounding area. It is
advised to build a shelter above the heat pump, to protect the device from direct rain and direct
sunlight.
c)
Do not install the device near road networks, as increased dustiness gradually worsens the
heat exchange.
d)
The air outlet must not be aimed at places, where cold air flow could cause any inconvenience
(windows, terraces, etc). Also, do not place the air outlet up the dominant winds.
e)
The distance between the swimming pool edge and the heat pump must not be shorter than
3,5 m. The suggested distance is 7 m. The total length of the connecting pipe should not
exceed 30 m. Please note, that the bigger this length is, the bigger the losses of the distributor
are.
f)
The heat pump must be placed on a flat and stable surface. The pump housing must be fixed to
this surface with screws or wood scews ,through rubber anti-vibration elements.Rubber anti-
vibration elements (silentblocks)not only reduce the noise level of the heat pump, but also
prolong their life-time.
g)
The rear surface of the evaporator consists of laminations, from soft metal. This surface can get
damaged very easily.Please be careful when positioning, to avoid any damage.
Notice: Please discuss the positioning and the connection to the indoor swimming pool with your
distributor!
