Microwave Radio CodeRunner 2, Operator'S Manual

Page: 31 / 50

Routine Operation 3-7 CodeRunner 2 Operator’s Guide/Tech Ref Manual
3.6 Frequently Performed Tasks
This chapter describes how to perform many common tasks with
the CodeRunner 2. Here are the tasks described:
Refer to the Main Screen display in Figure 3-3, and the menu
maps in Figure 3-4 and Figure 3-5 to follow along with these
instructions.
Topic Page
Turning the power ON and
OFF 3-7
Activating and deactivating
the transmitter 3-7
Switching between HI and
LOW power 3-7
Selecting Channel and
Offset 3-8
Switching between antennas 3-8
Switching antenna
polarization 3-8
Switching bands 3-8
Switching between Analog
and Digital modes 3-8
Setting for Remote
operation 3-9
3.6.1 Turning the power ON and OFF
1. Open the front panel of the Indoor Unit by loosening
the 2 large screws and letting the panel swing down.
2. Press the Power switch.
3. Close the front panel by swinging it up and tightening
the two screws.
3.6.2 Activating and deactivating the transmitter
1. Make sure the power to the CodeRunner 2 is on.
2. On the Main Screen,
- To activate the transmitter: press
PA
until the Status
Area displays
XMIT
.
- To deactivate the transmitter: press
PA
until the Status
Area displays
STDBY.
3.6.3 Switching between HI and LOW power
1. Make sure the power to the CodeRunner 2 is on.
2. On the Main Screen,
- To switch the transmitter to High power: press
Hi/Lo
until the Status Area displays
High
.
- To switch the transmitter to Low power: press
Hi/Lo
until the Status Area displays
LOW
.