Microwave Radio CodeRunner 2, Operator'S Manual

Page: 32 / 50

Routine Operation 3-8 CodeRunner 2 Operator’s Guide/Tech Ref Manual
3.6.4 Selecting Channel and Offset
1. Make sure the power to the CodeRunner 2 is on.
2. On the Main Screen,
- To change the channel on which the radio will
transmit: press
Chnl
until the Status Area displays the
channel desired.
- To change the frequency offset above or below the
selected channel: press
Offst
until the Status Area
displays the offset desired.
3.6.5 Switching between antennas
1. Make sure the power to the CodeRunner 2 is on.
2. Press the Antenna Select function button until the LED
illuminates next to the desired antenna.
3.6.6 Switching antenna polarization
1. Make sure the power to the CodeRunner 2 is on.
2. Press the Polarization Select function button until the
LED illuminates next to the desired polarization.
3.6.7 Switching bands
Which band(s) the CodeRunner 2 operates on is set by the
RFU(s) connected to the IDU. Switching bands in accomplished
by switching between RFUs:
1. Make sure the power to the CodeRunner 2 is on.
2. Press the Band Select function button until the LED
illuminates next to the desired RFU covering the
desired band.
3.6.8 Switching between Analog and Digital
modes
1. Make sure the power to the CodeRunner 2 is on.
2. On the Main Screen,
- To switch the transmitter to Digital mode: press
Di/An
until the Status Area displays
DIGITAL
.
- To switch the transmitter to Analog mode: press
Di/An
until the Status Area displays
ANALOG
.