Microwave Data Systems MDS entraNET 900, System Manual

Page: 101 / 148

MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide (Preliminary) 93
*Condition may be corrected by user and alarm cleared.
4.1.5 Correcting Alarm Conditions
(See View Event Log on Page 49 )
Table 4-6 provides insight on the causes of events that inhibit the unit
from operating, and possible corrective actions The Event Description
column appears on the
Event Log
screen.
EVENT_MAC MAC communication
Failed macCommunication(1)
EVENT_MACADDR MAC Address Invalid noMacAddress(6)
EVENT_NETNAME
* Netname Invalid invalidNetname(12)
EVENT_PLL_LOCK PLL Not locked pllLock(10)
EVENT_POWER_CAL Power Calibrated/Not
Calibrated powerCal(8)
EVENT_POWER_HIGH RF Power Control
Saturated High rfPowerHigh(13)
EVENT_POWER_LOW RF Power Control
Saturated Low rfPowerLow(14)
EVENT_RSSI
*
RSSI Exceeds
threshold rssi(11)
EVENT_RSSI_CAL RSSI Not Calibrated rssiCal(9)
EVENT_SYSTEM_ERROR* System Error Cleared;
Please Reboot systemError(16)
Table 4-5. Alarm Conditions (Alphabetical Order) (Continued)
Alarm Condition Reported Event Log Entry SNMP Trap
Table 4-6. Correcting Alarm Conditions
(Alphabetical Order)
Event Log Entry Generating Condition Clearing Condition
or Action
ADC Failure The ADC always reads the
same value (either high or
low limit) Contact MDS Technical
Services for assistance
AP Ethernet Link Monitor will check state of
Ethernet link and set alarm if
it finds the link down Ethernet link is re-established
Bridge Down When the Bridge fails to be
initialized Contact MDS Technical
Services for assistance
Flash Test Failed Internal check indicates
corruption of Flash memory Contact MDS Technical
Services for assistance
FPGA Failure Communication lost to the
FPGA Contact MDS Technical
Services for assistance
General System
Error Internal checks suggest unit
is not functioning properly Reboot the transceiver
Initialization Error Unit fails to complete boot
cycle Contact MDS Technical
Services for assistance