ArtixScan DI 6240S/6250S/6260S & ArtixScan TS 630S User's Manual 21
Paper Stopper and Paper Stabilizer Notice
The Paper Stopper is designed to prevent the paper stacks falling in a mess after
they were scanned and output into the output tray. Before scanning a stack of
papers, please follow the steps below to fix the Paper Stopper into the right
position in the tray, in order to keep output papers stay neatly in the tray after
the scan.
1. Pull out the Output Tray Extender.
Align the paper against
the side of output slot
located at the bottom of
the scanner.
2. Lift up either the Paper Stopper 1 or 2,
depending on the length of the paper.
3. Take out one piece of paper from the
Be sure the stopper
is lightly against the
edge of the paper.
Load the paper inside
the space between
the stopper and the
output slot of the
scanner.
stacks and put it in the output tray, laying it completely flat and bringing the
top or bottom edge of it into contact with the bottom of the scanner.
4. Push back the Output Tray Extender until the Paper Stopper touches the edge
of the paper.
Finally, load the papers to be scanned into the feed tray to start your
scanning.
NOTE:
The settling
position for the Paper
Stopper on the tray must
be equivalent to the length
of the paper. Incorrect
positioning of the Paper
Stopper will result in
disorders and mess for the
after-scanned outputs.