COIL ADDRESS
Label
Address
Label
Address
K1 inv
1632
2 STOP BITS
1763
K2 inv
1633
ADC SPEAD 0-HI; 1-LO
1764
K3 inv
1634
ADC TYPE
1765
Disable Clbr
1635
ZARO/START IN
2104
Disable button TARE
1636
K3
2107
Disable button ZERO
1637
K2
2108
TARE in mode B : 1-NO, 0-YES
1638
K1
2109
MODE: 0-A; 1-B
1639
TARE IN
2528
WR DISABLE (ENABLE ONLY FROM
1760
S1
2530
BROADCAST DISABLE
1761
S2
2531
EVEN PARITY
1762
●
For MS8347,
DEV ID = 5457
●
Float parameters are in IEEC754 format.
●
For
START/STOP
and
TARE
by network „cmd“ parameter is used
- Record of 90 is equivalent to activation of input Start for ~ 50ms
- Record of 150 is equivalent to activation of input Tare for ~ 50ms
- Record of 32 leads to Stop
The value is automatically reset after record of a value.
●
Indexes W2,W3 and W4 ….. the relevant parameters, selected by the positions of both inputs
for selecting of set-point S1 and S2.
●
The parameter A1 of the device screen is displayed x1024, ie read over the network 1 and the
menu of the device would be 1024.
●
Calibration in the network is the value of the reference weight is saved in PV.
●
The decimal point is decorative and the device doesn't scale. For example 111,22 appears on
the display but PV will be written 11122. This is the same for all parameters with weight
dimension.
●
The parameters with time dimension also be read as a whole numbers without decimal point.
●
For example 2.23 is readed 223
●
The response time of the device is determined by the ADC and the mode to be used, but it
can't be < 10 ms.
●
When А1=1024 the readings are obtained in ADC code respectively 18 bit for ADS and 20 bit
for AD.
0 mV is the middle of the range, and the negative value is displayed 0
●
The parameter A0 (offset of the measurement) is service informative. A0 = 0.
Not to be changed!
Document revision 2015-08-17
15
