III.
OPERATING MODE
The unit registers the input pulses and increases the accumulated value. Upon
reaching the set point, output K1 changes its state or generates a pulse of a certain
duration (see PROGRAMMING mode). The input pulses are blocked until a
Reset
input
signal resets the counter readings and changes the output status. A new counting starts
after Reset is dropped.
The output status is indicated by LED K1.
The action of the individual buttons is as follows:
By pressing and holding this button for more than 2 seconds, a mode of setting
the limit of accumulated pulses is entered. The display shows a limit value that can be
edited using the
UP and DOWN
buttons. To save the edited value, press the MODE
button again or do not press the button for more than 5 seconds.
,
When one of the two buttons is pressed, the display shows the number
of cycles performed by the counter (it is considered a completed cycle each time the
accumulated value is reset).
While pressing buttons
and
simultaneously the cycle counter is reset
Pressing and holding this button for more than 5 seconds enters the
"PROGRAMMING" mode, which is indicated by the red LED.
Document revision 2010-08-03
4