Microsonic TEL8018C, Manual

Page: 37 / 42

15
go back to
MEMO
„ TAM SETTINGS
Press
∧
or
∨
key to select
TAM SETTINGS
item.
1. TAM ON/OFF
Press
SET/OK
key to show
TAM ON/OFF
, then press
SET/OK
, the LCD display
ON
, press
∨
to select
OFF
or
ON
, and press
SET/OK
to confirm. If you have selected
ON
, the display shows
OGM1
, press
∨
key to
select
OGM2
or
OGM1
, then press
SET/OK
to confirm your selection.
2. SET OGM
Press
∨
key to show
SET OGM
, then press
SET/OK
to
SET OGM
, choosing
OGM1
or
OGM2
by pressing
∧
or
∨
key, press
SET/OK
to confirm.
Then press
∧
or
∨
to select
PLAY
,
RECORD
,
DEFAULT
, press
SET/OK
key to confirm your selection.
Select PLAY
If at step 4) you select “
PLAY
”, it will play the currently selected OGM.
Select RECORD
If at step 4) you select “
RECORD
”, it will prompt “
Please record new announcement after the
beep
”, and you can then speak into the handset microphone to record your personal announcement,
of up to 120 seconds. Then press
SET/OK
to end it.
Select DEFAULT
If you select
“DEFAULT”
, it will reset your OGM to the default pre-set announcement.
3. SET RING
Press
∨
key to select
SET RING
, press
SET/OK
to enter, press
∧
or
∨
to choose 2~9 or TOLL SAVER
rings. Press the
SET/OK
to confirm and return to previous menu.
Note:
If you don’t set a number, it will answer after 5 rings. If you want to dial in and check your messages
while you’re away, you can set
TOLL SAVER
--if there are new messages, the telephone will answer the call
after 2 rings, if there are no new messages, it will answer after 5 rings. So, if you call in and you don’t get an
answer after 2 or 3 rings, you can hang up and save on call charges.
4. TAM PIN
Press
∨
key to select
TAM PIN
, press
SET/OK
to enter and the display will show the current setting”0000”,
use the keypad to enter the new security PIN code(maximum 4 digits), press
SET/OK
to confirm. The security
code is used for remote control or to default the TAM and is a 4-digit code, the default security code is “0000”.
5. TAM DEFAULT
Press
∨
key to select
TAM DEFAULT
, press the
SET/OK
and the display will show
PIN?
, key in your TAM
security code number (default pin code is “0000”). Then press
SET/OK
to confirm the defaulted and the
display will return to idle mode.
OPERATION
To play/pause/stop messages on TAM
When there are new messages, the display will show e.g.
01/02 MSGS
, which means you have 1 new
message/2 messages altogether. In idle mode,
1. Press and hold
5
to listen to messages and memos, press
∧
or
∨
key to adjust the playing volume.
2. Press
5
again to pause during a message. The pause time maximum is one minute. If not quit from
pause in one minute, then it will stop and quite the message play after one minute automatically. If you
want to stop completed the playing of the message, then press
8
key imprinted.