Microsemi PD69200, User Manual

Page: 12 / 19

PD-IM-7648 Evaluation System - User Guide
Copyright © 2013
Microsemi
12
Rev 1.0 / 25 Dec 13 Analog Mixed Signal Group
1 Enterprise, Aliso Viejo, CA 92656, USA; Phone (USA): (800) 713-4113, (ROW): (949) 221-7100 Fax: (949) 756-0308

Manufacture part number: CH74162V100
MB: J2, DB: J7
Pin No. Signal Name Description
1 PG0 Power good signal, power supply status indication
2 PG1 Power good signal, power supply status indication
3 PG2 Power good signal, power supply status indication
4 PG3 Power good signal, power supply status indication
5 xReset_IN Reset signal to PoE application (used for cascading purposes).
6 xDisable_ports Disable_ports signal to PoE application (used for cascading purposes).
7 xPoE_RESET Reset signal to PD69208 ICs (used for cascading purposes).
8 xHSWP Hot Swap control signal, used when PoE application is hot swappable.
9 BKGD PoE controller burning signal.
10, 11,
17, 18,
21, 23,
24, 29 GND_D Digital ground at PoE domain.
12, 13 Reserved Reserved
12 SDA_in_auto_mode I
2
C SDA_in – Data I
2
C signal (used for cascading purposes).
14 SDA_out_auto_mode I
2
C SDA_out – Data I
2
C signal (used for cascading purposes).
15 SCL_auto_mode I
2
C SCL – Clock I
2
C signal (used for cascading purposes).
19 LED_SCK Clock LED signal – Running to LED indication board.
20 LED_DATA Data LED signal – Running to LED indication board.
22 LED_Latch Latch LED signal – Running to LED indication board.
25 ESPI_CS ESPI 'chip select' signal (used for cascading purposes).
26 ESPI_MOSI ESPI 'master out slave in' signal (used for cascading purposes).
27 ESPI_MISO ESPI 'master in' slave out' signal (used for cascading purposes).
28 ESPI_SCK ESPI clock (used for cascading purposes).
30 VAUX3P3 3.3 VDC = VAUX3P3 and 3V3_AUX, application's reference voltage
(isolated from hosting system domain), referenced to 'GND_D.'
Figure 11: Communication and Indication Connectors

Manufacturer: CviLux

Manufacture part number: CH74302V100
5. Isolated External Host (see Figure 12)
This host transmits control and indication signals beween the hosting system and MB. There is limited use for this
connector as most communication is via USB, RS232 or UART.
MB: J4