Microsemi Outdoor Power View Pro, User Manual

Page: 32 / 44

Power Over Ethernet Power View Pro User Guide
Copyright

2013
Microsemi
32
Rev.1.0, 17-Dec-13 Analog Mixed Signal Group
1 Enterprise, Aliso Viejo, CA 92656, USA; Phone (USA): (800) 713-4113, (ROW): (949) 221-7100 Fax: (949) 756-0308

For SNMPv3, make sure username, authentication and privacy password and encryption methods
match your SNMP manager configuration.
2. Traps:

To enable traps set remote manager IP address in the Remote IPv4/IPv6 SNMP Trap Managers
window.

To enable PoE traps (PoE port status changed, unit consumes over xy% of total unit power, or unit now
consumes less than xy% of total unit power), please enable PoE Notifications (see image below).
Figure 5-2: Enable SNMPv2, SNMPv3 and PoE traps
5.2 SNMP MIBs
Several MIBs are supported by SNMP manager.

RFC1213 : MIB-II which provides general IPv4 network statistics, and information on the device being
managed.

RFC3621 : Power Over Ethernet (PoE) MIB which provides various management capabilities (see
Figure 5-3)

Private MIB : Enhance PoE functionality beyond RFC3621 PoE MIB.
5.3 RFC3621 PoE MIB
NOTE:
For a detailed PoE MIB description, please
refer to Microsemi’s Technical Note – 132 (can be
found on the CD), which describes in detail PoE MIB functionality .