10
Pairing of Sensor and Relay
The Mkomfy set with sensor and relay in the same pack are already
paired. If you have bought a separate sensor, this must be paired with
the relay.
This can be done in two different ways.
Read through the whole instruction for both alternatives before performing pairing!
Alternative 1:
Pairing of Sensor without physical intervention on relay.
1.
Activate Sensor in pairing mode by setting DIPSW6 to active [ON].
2.
Disconnect the power to Relay for 5 seconds by turning the
relevant protection circuit off and on.
- Within 20 seconds of turning the protection circuit on:
Hold in the function button on the sensor for 6 seconds.
The sensor will emit a sound signal every 2 seconds, if pairing
has succeeded.
3.
Disconnect the power to Relay again for 5 seconds by turning
the relevant protection circuit off and on.
NB! This must be done within one minute of powering the relay
under Point 2, or the pairing will not be saved
4.
Set DIPSW 6 back to inactive [OFF].
Pairing is now complete.
Alternative 2:
Pairing of Sensor by activation of programming button on relay.
1.
Activate Sensor in pairing mode by setting DIPSW6 to active [ON].
2.
Briefly press the programming button on Relay. Yellow diode
will now begin to flash. The relay will now be in pairing mode
for 30 seconds.
3.
Hold in the function button on the sensor for 6 seconds while
the yellow LED flashes. The sensor will emit a sound signal every
2 seconds, if pairing has succeeded.
4.
Set DIPSW 6 back to inactive [OFF].
NB: It is not possible to have more than 1 Mkomfy Sensor connected to the Relay
at the same time. Pairing a new sensor will automatically delete the sensor
already paired with the Relay.
Installation information
