EN
8.6 Lot Number Setup
LOT NUMBER
OK
BACK
-
+
ON
You can press the functional “+” and “-”
buttons to enable or disable the LOT
NUMBER input function. If the LOT NUMBER
input function is enabled, you will be asked
to enter the Lot Number before performing
each test. The Lot Number contains the
expiration date of the strip. The meter will
check whether the current date exceeds the
expiration date of the strip. If the current date
exceeds the expiration date, the meter will
report an error.
NOTE:
Please make sure the date setting is correct if you want to use the
input function of LOT NUMBER.
8.7 Setting a Target Range For Your INR Results
An INR target range may be set to alert the user when the INR results are
out of range.
If results fall outside the target range, or if results fall within
the target range but are not consistent with the patient’s
current state of health (e.g. they have symptoms such
as bleeding or bruising) follow your usual procedures for
taking corrective action.
Each physician should establish expected values for his or
her patient population or individual patients. Differences in
reagents, instruments and pre-analytical variables can affect
prothrombin time results. These factors should be considered
when comparing different prothrombin time test methods.
For the self-testing user, always contact your health care
provider before setting an INR target range. Follow your health
care provider’s instructions for the correct actions to take.
OK
-
+
NEXT
TARGET:
ON
0.7 1.5
Use “+” and “-”buttons to switch between
the Target ON and OFF modes. If “OFF” is
selected, the meter does not respond to any
operation when pressing “NEXT”. If “ON” is
selected and “NEXT” is pressed, refer to the
following sections.
13
