Tigercat System Board Manual
Chapter 3: Installing the Tigercat
27
2. Place the Retention Base over the Slot 1 connector
and insert it down into the Support Bridges with
studs. Note the Keyed location of both Slot 1 and
the Retention Base.
3. Using a screwdriver, tighten all four
sides of the Retention Base.
Installing a CPU
Follow the steps below to install the Pentium II processor:
1. Locate the Slot 1 connector (refer to Figure 2-1).
2. If you are installing the boxed version of the Pentium
II processor, follow the instructions in the section
CPU Installation (Boxed version).
3. If you are installing the
optional
Heat Sink Support,
continue to step 4; if not, go to step 5.
Retention Base
Keyed
