3-2
Micronics M54Hi-Plus System Board Manual
Installation of the M54Hi-Plus
The installation of the M54Hi-Plus system board depends on the type of case
you use. The M54Hi-Plus is an integrated baby AT size system board and
may be installed into most cases.
Prior to installing the M54Hi-Plus, make sure you have a clear work space
available and adhere to all anti-static precautions.
If you are unfamiliar with installing a system board, Micronics highly
recommends you read the computer user’s manual or contact your dealer’s
technical support department.
Tools Required
Micronics recommends using the following tools to install the M54Hi-Plus:
Small Phillips screwdriver.
Tweezers or a pair of needle-nose pliers.
Tray (to hold loose screws).
Equipment Required
Micronics recommends using the following equipment with the M54Hi-Plus
for a typical configuration:
Chassis with standard hardware.
A high quality power supply capable of providing continuous power
within a 5 volt range, plus or minus 5% (eg. 4.75 to 5.25). A power
filter may be used with a noisy AC power source.
AT compatible keyboard (AT Version).
PS/2 compatible keyboard (PS/2 Version).
Eight ohm speaker.
Standard ribbon cables for internal connections.
Standard power cord (grounded).
CPU heat sink with cooling fan (strongly recommended).
