20
Alive Indicator or gateway is received, the connection
is considered OK. If there is no response received after
4 tries, the connection is considered as failed.
HTTP:
The device gets TCP connection with the Alive
Indicator first. Then the device sends HTTP HEAD packet
to the Alive Indicator. If any HTTP DATA from the Alive
Indicator is received, the connection is considered OK. If
there are no responses received after 5 tries, the
connection is considered as failed.
Traffic:
If there is no traffic on the WAN port in the Interval
time, the connection is considered as failed
•
Interval
– The period to check if the WAN port is alive or not.
•
Alive Indicator
– This is used for the ICMP or HTTP Method
to determine if your Internet connection is active or not. (You
can enter either the IP address or host name
Transparent
Bridge
Option
•
Bridge Mode
– If Set to Enable, traffic from Lan hosts with
real IPs can go through the specific WAN port without NAT
translation. This device works like a bridge switch for that
specific WAN port.
•
NetBIOS Broadcast
– If enabled, NetBIOS Broadcast
packets are allowed to pass through the device.
•
ARP Table
– ARP Table is used by the device to determine
the bridge hosts location (eg. inside/outside WAN and which
WAN). Its size can be adjusted if needed.
4.2 Advanced
PPPoE
In order to use multiple PPPoE sessions on the same WAN port, configuring the following
screen is required.
This can also be used to manually connect or disconnect a PPPoE session.
