19
3.2. The Rear Panel
The rear panel of the ADSL Router is shown below
Power
Connection
Plug the circle end of the power adapter firmly into the rear panel of
the ADSL Router, and the other end put into an electric service outlet
then the system is ready.
LAN
Connection
10BASE-T: Category 3,4 or 5 UTP/STP
100BASE-TX: Category 5 UTP/STP
WAN
Connection
ADSL: RJ-11 for AnnexA (SP3353),
RJ-45 ISDN for AnnexB (SP3353/B)
3.3. Installing And Using Internet ADSL Router
This section provides a step-by-step guide to the installation and configuration of
the ADSL Router. It assumes that your computer uses the Windows 95/98 or newer
version and a web browser is installed for configuration purposes. We suggest you
go over the whole section and then do more advanced operation.
3.3.1. Network configuration setup
Steps to build up the network:
(1) Check your ADSL service is enabled and splitter is well installed. If not,
consult to your ISP.
(2) Connect the phone line from the ADSL splitter to the RJ-45 port on the rear
panel of the ADSL Router.
(3) Install the network interface card into your computer by referring to the User
Guide that came with the card.
