Video Wall Installation Manual – 6WX1H
Page 20
Rev. 09/2019
Step 8 – Monitor Alignment
Instructions
Diagrams
IMPORTANT:
First proceed to Step 9 on next page to gain access to monitor requiring vertical alignment.
Aligning Monitors Inwards/Outwards
The monitors share the same top rail, in
almost all cases the front face of monitors
will always line up to each other.
To align bottom of two (2) adjacent
monitors an inward/outward micro
adjustment screw is located on lower
section of each Panel VESA Bracket. See
figure 8A.
•
To move bottom of monitor outwards
hand turn alignment screw counter
clockwise.
•
To move bottom of monitor inwards
hand turn alignment screw clockwise.
Fig. 8A
Aligning Monitors Horizontally
•
Once you have access to desired
monitor and while monitor is still
attached to mounting rails;
•
Simply slide the monitor on horizontal
rail to desired position.
Fig. 8B
Aligning Monitors Vertically
Top or bottoms of two (2) adjacent
monitors do not align evenly. See figure 8D.
IMPORTANT:
If the monitors require more than
+-3mm adjustment stop and
recheck you followed installation
instructions correctly.
•
Once you have access to desired
monitor and while monitor is still
attached to mounting rails;
•
Turn the top screw clockwise to slowly
raise the end of monitor. See figure 8C.
•
Turn the top screw counter clockwise
to lower the end of monitor. See figure
8C.
Fig. 8C
Fig. 8D
