5
Connect the snap connector from the control panel to
the connector on the end of the cable. Temporarily
hang the control panel on the bracket.
Warning: Do
not power up the control panel yet.
7
Run the cable inside the property to the point of exit
where the the outside siren is to be installed. Drill a
hole through the inside wall to the outside and thread
through the cable to the outside. Use cable clips to
hold the cable near the exit hole.
8
Use a suitable platform to work from and use the
siren box as a template to mark the position for the
fixing screws. Drill holes 25mm deep and insert
masonry plugs.
9
Bring the cable to the positon of the siren box and cut
the cable, allowing enough surplus for wiring into the
siren terminal block. Strip the wires and connect them
to the teminal block as shown.
Fix the siren to the wall with the fixing screws. Start at
the control panel and secure the cable run with cable
clips. Reserve some clips for wiring the PIR and door
contacts.
CHECK LIST
Have you planned the layout?
Is the control panel near a power socket?
Have you temporarily placed the control
panel on the fixing bracket?
Are the snap connectors connected?
Is the wiring to siren box completed?
Has the wiring been secured with cable clips?
11
wall
plugs
10
FFo
ollllo
ow
w ssa
affe
ettyy p
prre
ecca
au
uttiio
on
nss
w
wh
he
en
n u
ussiin
ng
g lla
ad
dd
de
errss..
www.ukpanels.com
