Rotationsmikrotom HM 355 S
MICROM International GmbH
Robert-Bosch-Str. 49
D- 69190 Walldorf
387840 - Deutsch
3-2 INITIAL
TURN-ON
Note:
The kind of the used examination
materials and all special conditions for
their processing, pre-treatment and, if
necessary, storage as well as instrument controls
for correct and safe operation is in the
responsibility of the operator.
The operator is also responsible for special
equipment and materials and/or reagents for the
operation of the instrument.
Warning:
Before turning on the instrument for the
first time, please check if the power
requirements indicated on the type
plate correspond to the power supply voltage
being used.
The operating panel, which is separately packed,
can be attached to the instrument or used
freestanding. First connect the operating panel
with the instrument:
•
A control cable (fig. 3.1) is fixed on the rear
side of the instrument.
•
Connect this cable with the connector on the
rear side of the operating panel.
•
Should the operating panel be attached to the
instrument, push the connector through the
corresponding hole (fig. 3.2) on the rear side
of the microtome.
•
Turn the connector 90° and push it through
the hole on the front of the instrument.
•
Plug the connector into the operating panel.
Fasten the cable on the panel with the two
screws.
•
To clear away the cable, insert it into the
corresponding holders (fig. 3.3) on the back of
the microtome.
The operating panel can be used freestanding. It
can be placed on the left as well as on the right
side of the microtome.
•
For this, the operating knobs can easily be
removed and placed on the other side of the
operating panel.
Fig. 3
