Microlife BP3NC1-1W, Instruction Booklet

Page: 15 / 47

immediately afterwards the "M" button and hold both
down until the bell symbol appears in the bottom left of
the display. Then release both buttons. The flashing "1"
in the display indicates that the first alarm time can now
be set.
2. Press the time button to set the hours – the hours dis-
play flashes and pressing the "M" button allows you to
set the alarm hour. To confirm, press the time button.
3. The minute display will now flash. The minutes can be
set using the "M" button. To confirm, press the time but-
ton again.
4. The bell symbol will now flash. Use the "M" button to
select whether the alarm time is to be active (bell) or
inactive (crossed-out bell). To confirm, press the time
button.
To set a second alarm time, proceed as above but
if the "1" flashes, press the "M" button to select "2"
and confirm with the time button.
• An active alarm time is indicated by the bell symbol in the display.
• The alarm sounds at the set time every day.
• To switch-off the alarm when it is sounding, press the START/ON/OFF but-
ton.
• To permanently switch-off the alarm, proceed as above (steps 1-4)
and select the crossed-out bell symbol. This will then disappear from
the display.
• The alarm times must be re-entered each time the batteries are replaced.
14
TIME PM