6
Using rechargeable batteries
You can also operate this instrument using rechargeable batteries.
➢
Only use «NiMH» type reusable batteries.
➢
The batteries must be removed and recharged once the battery
symbol (flat battery) appears! They must not remain inside the
instrument, as they may become damaged (Low use of the
instrument may result in discharge, even when it is switched off. ).
➢
Always remove the rechargeable batteries, if you do not intend
to use the instrument for a week or more!
➢
The batteries can not be charged in the blood pressure monitor!
Recharge these batteries in an external charger and read the
information regarding charging, care and durability!
9. Error Messages
If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g. «
ERR 3
», is displayed.
Error
Description Potential cause and remedy
«
ERR 1
» Signal too
The pulse signals on the cuff are too weak.
weak Re-position the cuff and repeat the
measurement.*
«
ERR 2
» Error signal During the measurement, error signals
were detected by the cuff, caused by
movement or muscle tension. Repeat the
measurement, keeping your arm still.
«
ERR 3
» No pressure An adequate pressure cannot be generated
in the cuff
in the cuff. A leak may have occurred.
Check that the cuff is correctly connected
and is not too loose. Replace the batteries
if necessary. Repeat the measurement.
«
ERR 5
» Abnormal
The measuring signals are inaccurate and
result no result can therefore be displayed.
Read through the checklist for performing
reliable measurements and then repeat the
measurement.*
«
HI
»
Pulse or cuff The pressure in the cuff is too high (over
pressure too 300 mmHg) or the pulse is too high (over
high
200 beats per minute). Relax for 5 minutes
and repeat the measurement.*
Error
Description Potential cause and remedy
«
LO
»
Pulse too
The pulse is too low (less than 40 beats per
low
minute). Repeat the measurement.*
* Please consult your doctor, if this or any other problem occurs
repeatedly.
➢
If you think the results are unusual, please read through the
information in «Section 1.» carefully.
10. Safety, Care, Accuracy Test and Disposal
Safety and protection
•
This instrument may be used only for the purpose described in
this booklet. The manufacturer cannot be held liable for damage
caused by incorrect application.
•
This instrument comprises sensitive components and must
be treated with caution. Observe the storage and operating
conditions described in the «Technical Specifications» section!
•
Protect it from:
- water and moisture
- extreme temperatures
- impact and dropping
- contamination and dust
- direct sunlight
- heat and cold
•
The cuffs are sensitive and must be handled with care.
•
Only pump up the cuff when fitted.
•
Keep the instrument away from strong electromagnet fields such
as mobile telephones or ration installations.
•
Do not use the instrument if you think it is damaged or notice
anything unusual.
•
Never open the instrument.
•
Remove the batteries if the instrument is not going to be used
for a prolonged period.
•
Read the further safety instructions in the individual sections of
this booklet.
Ensure that children do not use the instrument unsupervised;
some parts are small enough to be swallowed.
