aponorm
®
by
16
5. Data Memory
This device automatically stores up to 99 measurement values.
Viewing the stored values
Press the M-button
9
briefly, when the device is switched on.
The display first shows «
M
»
19
and then an average value. The
device then switches to the last stored value.
Press the M-button again to exit the memory mode. Pressing the
«+»
11
or the «-»
10
button repeatedly enables you to move from
one stored value to another.
Memory full
Pay attention that the maximum memory capacity of 99
memories is not exceeded.
When the 99 memory
is full, the oldest value is automatically overwritten
with the 100th value.
Values should be evaluated by a
doctor before the memory capacity is reached –
otherwise data will be lost.
Clearing all values
If you are sure that you want to permanently remove all stored
values, hold down the M-button
9
until «
CL
» appears and then
release the button.
Press the M-button while «
CL
» is flashing to permanently clear
all values.
Cancel deletion:
press START/STOP button
1
while
«
CL
» is flashing.
Individual values cannot be cleared.
6. Battery indicator and Battery change
Low battery
When the batteries are approximately ¾ empty the battery
symbol
17
will flash as soon as the device is switched on (partly
filled battery displayed). Although the device will continue to
measure reliably, you should obtain replacement batteries.
Flat battery – replacement
When the batteries are flat, the battery symbol
17
will flash as
soon as the device is switched on (flat battery displayed). You
cannot take any further measurements and must replace the
batteries.
1. Open the battery compartment
5
on the bottom of the
device.
2. Replace the batteries – ensure correct polarity as shown by
the symbols in the compartment.
3. To set date and time, follow the procedure described in
«Section 2.».
The memory retains all values although date and time
must be reset – the year number therefore flashes
automatically after the batteries are replaced.
Which batteries and which procedure?
Use 4 new, long-life 1.5 V, size AAA batteries.
Do not use batteries beyond their date of expiry.
Remove batteries if the device is not going to be used for
a prolonged period.
