Microlife AFIB BT, Manual

Page: 14 / 18









100th value. Values should be evaluated by a doctor before the memory capacity is
reached – otherwise data will be lost.
Clearing all values
1. Hold down the M-button (11) until « CL » appears and then release the button. when the device is
switched off.
2. Press the M-button while « CL » is flashing to permanently clear all values of the selected user.
Cancel deletion: press START/STOP button (1) while « CL » is flashing.
Individual values cannot be cleared.
10. Battery Indicator and Battery change
Low battery
When the batteries are approximately ¾ empty the battery symbol (19) will flash as soon as the
device is switched on (partly filled battery displayed). Although the device will continue to measure
reliably, you should obtain replacement batteries.
Flat battery – replacement
When the batteries are flat, the battery symbol (19) will flash as soon as the device is switched on (flat
battery displayed). You cannot take any further measurements and must replace the batteries.
1. To set date and time, follow the procedure described in «Section 3»
2. Open the battery compartment (5) on the bottom of the device
3. Replace the batteries – ensure correct polarity as shown by the symbols in the compartment.
The memory retains all values although date and time must be reset – the year number
therefore flashes automatically after the batteries are replaced.
Which batteries and which procedure?
Use 4 new, long-life 1.5V, size AAA batteries.
Do not use batteries beyond their date of expiry.
Remove batteries if the device is not going to be used for a prolonged period.
Using rechargeable batteries
You can also operate this device using rechargeable batteries.
Only use «NiMH» type reusable batteries.
Batteries must be removed and recharged when the flat battery symbol appears. They should
not remain inside the device as they may become damaged (total discharge as a result of low
use of the device, even when switched off).
Always remove the rechargeable batteries if you do not intend to use the device for a
week or more.
Batteries cannot be charged in the blood pressure monitor. Recharge batteries in an external
charger and observe the information regarding charging, care and durability.
11. Using a Mains Adapter
You can operate this device using the Microlife mains adapter (DC 6V, 600mA).
Only use the Microlife mains adapter available as an original accessory appropriate