Microlife 47038, Manual

Page: 19 / 65

19
aponorm ® Mobil Plus
EN
4. Appearance of the Heart Arrhythmia Indicator for
early Detection
This symbol AM indicates that certain pulse irregularities were
detected during the measurement. In this case, the result may
deviate from your normal blood pressure – repeat the measurement.
In most cases, this is no cause for concern. However, if the symbol
appears on a regular basis (e.g. several times a week with measure-
ments taken daily) we advise you to tell your doctor. Please show
your doctor the following explanation:
Information for the doctor on frequent appearance of the
Arrhythmia indicator
This instrument is an oscillometric blood pressure monitor that also
analyses pulse frequency during measurement. The instrument is
clinically tested.
The arrhythmia symbol is displayed after the measurement, if pulse
irregularities occur during measurement. If the symbol appears
more frequently (e.g. several times per week on measurements
performed daily) we recommend the patient to seek medical
advice.
The instrument does not replace a cardiac examination, but serves
to detect pulse irregularities at an early stage.
This blood pressure monitor allows you to store the results for two
individual users. In addition, there is a guest mode, in which the
results are not stored.
Alternating between 2 users or the guest mode:
1. While the unit is switched off, keep the time button pressed
for 3 seconds until the user symbol flashes.
2. Press the M-button to change between user 1, user 2 and the
guest
mode.
3. Confirm the selection by pressing the ON/OFF button .
6
5
AL 6
1
5. User Selection
5. Data Memory
At the end of a measurement, this instrument automatically stores
each result, including date and time.
Viewing the stored values
Press the M-button
5
briefly, when the instrument is switched off.
The display first shows « M »
AL
and then a value, e.g. « M 17 ». This
means that there are 17 values in the memory. The instrument then
switches to the last stored result.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to toggle between one stored
value and another.
6.