5.8. Memory – displaying the last 99 measurements
The measured results are stored in the instrument until a new
measurement is carried out. With the unit in the OFF position,
press and hold the MEMORY button for at least 3-seconds. The
screen will first show the average of all readings in memory (icon
shown is “A”) followed by the most recent readings along with time
and date. The MR symbol is displayed in the lower left. Release the
button.The last reading will be displayed. Each time you press the
memory button an earlier measurement will be displayed along with
time and date. If an irregular heartbeat interval was detected in any
measurements stored in memory, the icon will be displayed.
Before you delete all readings stored in the memory, make sure you will not need refer
to the readings at a later date. Keeping a written record is prudent and may provide
additional information for your doctor’s visit.
In order to delete all stored readings, depress the MEMORY button for at least 7 sec-
onds, the display will show the symbol " CL” and 3 short beep sounds will be heard to
indicate deletion of stored readings.
5.9. Discontinuing a measurement
If it is necessary to interrupt a blood pressure measurement for any reason
(e.g the patient feels unwell), the ON/OFF button can be pressed at any time.
The device then immediately lowers the cuff pressure automatically.
6. Blood Pressure Analyzer Software
Included with ID #3AC1-PC, 3AC1-PCCOS, optional accessory for 3AC1-AP. Call microlife at 1-800-568-4147 or visit microlife at
www.microlifeusa.com to order)
This unit can be used in connection with your personal computer (PC) running the
Microlife Blood Pressure Analyzer (BPA) software. Your PC will allow a capacity of
monitoring 80 patients, each with 1000 data (note: overuse will lower system
efficiency).The memory data can be
transferred to the PC by connecting the
monitor via cable with the PC.
13
MR
MR
Last
reading
14 readings
in memory
14
Summary of Contents for 3AC1-AP
Page 21: ...20...
