Microhard Systems MHX-900, Operating Manual

Page: 13 / 34

MHX-900 Operating Manual: Chapter 3 Configuration Options
9
Q Quiet Mode
Your modem is preset to send responses when it executes commands, and
there after to keep the host informed of its status.
*Q0 Enable modem responses
Q1 Disable modem responses
V Result Codes display
Your modem can either display result codes as words or numbers.
V0 Display Result Codes as numbers
* V1 Display Result Codes as words
W Connection Result
The W command returns your modem to the Data Mode from the Command
Mode
*W0 Reports computer (DTE) rate as CONNECT xxxx
W1 Reports computer (DTE) rate and wireless rate between
modems as CARRIER xxxx.
W2 Reports modem (DCE) rate as CONNECT xxxx
Z Reset and load stored configuration
The Z command resets the modem and loads the stored configuration.
&C DCD (Data Carrier Detect)
The &C command controls the modems DCD output signal to the host
microprocessor. This command determines when the DCD is active.
&C0 DCD is always ON
* &C1 DCD on when modems are synchronized
&D DTR (Data Terminal Ready)
The &D command controls what action the modem performs when the DTR
input line is toggled. The DTR input is controlled by the host
microprocessor.
&D0 DTR line is ignored
&D1 Not Supported
* &D2 DTR disconnects and switches to Command Mode
&D3 DTR disconnects and resets modem
&F Load Factory Default Configuration
The &F command resets the modem and loads the default factory
configuration.
&K Handshaking
The &K command controls the handshaking between the modem and host
microprocessor.
&K0 Disable handshaking
* &K3 Enable hardware handshaking (RTS/CTS)