microHAM SMORF, Manual

Page: 69 / 76

micro HAM © 2015 All rights reserved
REMOTE CONTROL APPLICATION
SMΩRF Remote Control Application is native, touch screen friendly application for Windows and OS-X provided
by
micro HAM, which fully exploits strengths of direct TCP connection to the SMΩRF, providing real time access
to the SMΩRF measurements. Application can be downloaded from www.microham.com .
After installation and first start it is necessary to
click on SETUP button and set connection
parameters. Set desired Session name, enter
SMΩRF's IP address and DATA port, User name
and Password, and MAC address. DATA port and
MAC address can be found in LAN SETTINGS
menu.
Than move session into Sessions window clicking
on
< button. Make new session active, and click
Save button on the bottom to save entered
parameters. Click Connect and you should get in.
That's the quick start but Remote Control Setup
allows to set more parameters.
1.
Sessions List
Shows all sessions and their parameters.
Session can be overwritten by moving same
sessions name into list by < button .
Highlighted session can be deleted by X
button.
2.
Active session
Sets active session for connection. Active
session can be assigned for auto-connect
when Connect after start-up box is checked.
3.
Options
Switch to COMPACT mode after connected – Remote Control starts in COMPACT mode.
Preserve window layout – remembers position of normal window as well as compact window on desktop.
Stay on top – sets application to stay on top of other programs on desktop.
Log communication – logs data exchange for troubleshooting. Do not check it until you're asked.
Show peak hold for top bargraph where applicable – shows power peak hold segment on top bargraph.
Show peak hold for bottom bargraph where applicable – shows power peak hold segment on bottom
bargraph.
4.
AUTO range switch to lower timeout
Sets down-ranging time. This setting is equivalent to the BAR DOWNRANGING parameter from the
SYSTEM MENU | MISCELANEOUS. Since Remote Control application has independent settings, this
parameters is set separately.
5.
Polling rate
Sets polling rate. This setting allows to limit data amount transferred between the SMΩRF and the
Remote Control application what can be useful if SMΩRF is located on remote site where you pay for
Internet data amount.
Remote Control application can work in two forms, NORMAL and COMPACT. In COMPACT mode it doesn't
allow any settings and uses bar graphs settings and first two measurements from the NORMAL mode.
69
2
3
4
5
1