microHAM © 2010 All rights reserved
2.
For Icom transceivers, install the ICVOX jumper located behind the
PTT IN jack. Otherwise, connect your transceiver PTT Out (linear) to
the PTT IN jack using the appropriate cable.
3. Connect your amplifier PTT (if used) to the PA PTT jack and set the PA
PTT RE/SS jumpers appropriately.
4. Connect your keyer paddles to the PADDLE jack.
5. If you use a foot switch, connect the foot switch to the FOOTSW jack.
6. Plug the DB15M on the radio cable set into the DB15 (RADIO) connector on the rear panel of DIGI
KEYER II and connect each connector from the cable set to the appropriate jacks at the rear panel
of your transceiver. Each connector on the radio interface cable is marked same as the matching
jack on your transceiver.
7. If the radio cable ends with leads for external power, connect these leads to a 12-16V DC power
supply. Be sure to observe the proper polarity.
NOTE: DO NOT use the same power supply as the transceiver.
8. Locate but do not connect the USB cable from DIGI KEYER II to your computer.
NOTE: If you will be installing on a Windows computer, skip to page 9.
Mac OS X INSTALLATION
1.
Insert the microHAM CD in your CDROM/DVD drive and navigate to Drivers/OS-X or use your web browser to
go to http://www.ftdichip.com/Drivers/VCP.htm and down load the latest driver image for OS-X.
2.
Open FTDIUSBSerialDriver_v2_2_14.dmg by
clicking on it.
3.
For OS-X 10.4, 10.5 or 10.6 open
FTDIUSBSerialDriver_10_4_10_5_10_6 and
follow the instructions to install.
4.
Plug in the USB cable
5.
Turn on the radio or external power supply.
6.
Follow the instructions for your software to
configure the application to work with DigiKEYER
II.
NOTE: To access all the capabilities of DigiKEYER II, your OS-X software must be written to use the
microHAM Keyer Protocol or µH Router by Kok Chen, W7AY.
8
