3
- To keep the LED display always on press MODE & UP simultaneously. Press MODE & OFF simultaneously for the LED
display to auto shut off after 20 seconds of inactivity.
Use MODE button to choose the required working mode, then using UP and DOWN to adjust the relative reference data
：
A
．
Single Colour
：
under this mode
，
LED display shows “C.L.X”, “X”=0-7, press UP or DOWN button to adjust “X”.
0---BLACK 1---RED 2---green 3---blue 4---purple 5---yellow 6---cyan 7---white
B
．
Colour change: under this mode, LED display shows “J. X X”, “X X”=01-99 means the speed of colour change, press UP or
DOWN button to adjust the speed of colour change.
C
．
Colour fade: under this mode, LED display shows “F.X.X”, “X X”=( 01~99
）
means the speed of colour fade, press UP or DOWN
button to adjust the speed of colour fade.
D
．
Auto mode
：
under this mode, LED display shows “A - -“, auto run the colour change and colour fade.
E
．
Sound mode
：
under this mode, the LED display shows “S.XX”, “XX”=
（
00~31
）
means levels for sound sensitivity. Press UP or
DOWN button to adjust the levels of sound sensitivity.
F
．
Slave mode
：
under this mode, the LED display shows “S.L.A.”
，
the master fixture decides the running state of current fixture
，
the above A~E all have master function.
G
．
DMX mode
：
under this mode, the LED display shows “X X X” or “C.H.X”. Press MODE button to select them. When “XXX” is
displayed, press UP or DOWN button to select the DMX address 1-512. When “C.H.X” is display, press UP or DOWN button to
select two DMX modes: “C.H.4” means it is in 4 channel mode, “C.H.6” means it is in 6 channel mode. Without connecting the DMX
controller, the display will flicker, and blackout.
4. MOUNTING AND INSTALLATION
Caution:
For added protection, mount the fixtures in areas outside walking paths, seating areas, or in areas were the fixture might
be reached by unauthorized personnel. Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device’s weight. Fixture installation must always be secured with a secondary safety attachment,
such as an appropriate safety cable. Never stand directly below the device when mounting, removing, or servicing the fixture.
Whether installing inverted on a truss or ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept at
least 0.5m (1.5 ft) away from any flammable materials (decoration etc.). Always use and install the supplied safety cable as a safety
measure to prevent accidental damage and/or injury in the event the clamp fails.
Mounting Points:
Overhead mounting requires extensive experience, including calculating working load limits. A knowledge of the
installation material being used, and periodic safety inspection of all installation material and the fixture are all imperative and should
only be performed by a qualified technician. Improper installation can result in bodily injury and damage.
Be sure to complete all rigging and installation procedures before connecting the main power cord to the appropriate wall outlet.
Floor Mounting:
Set the 2 brackets at your desired angle and aim your fixture accordingly. Please see diagram below.
