Microframe Corporation
Series 3007 - DataPage Lite Transmitter
7
1 INSTALLATION PROCEDURES
Figure 1: Connecting the Antenna and Locking Cover
1.1 CONNECTING THE ANTENNA
Connect the 90 degree antenna to the BNC
connector located at the side of the transmitter.
Slide the plastic cover over the connector,
engaging the two lugs into the corresponding
recesses in the side of the case. This will
maintain the antenna in an upright position,
which is important for optimizing the range of
the transmitter (See Figure 1).
1.2 CONNECTING POWER SUPPLY
Connect the AC adapter power lead to the
power socket located at the far right-hand rear
corner of the base station (See Figure 2).
Plug the power supply into a convenient
wall socket and turn on the power. When the
unit is first powered up, the system will display
the following screen for a few seconds:
DATAPAGE
LITE
Followed by:
PAGER: (1-9999)
>
The flashing cursor invites you to enter a
pager number (this can be any number between
1 and 9,999) after which you must press SEND
to transmit a page. See "Operation" for further
transmitting procedures.
IMPORTANT NOTE:
Use only the power supply included with
your system! The use of non-approved
power supplies will invalidate all war-
ranty and service.We also recommend
using a surge suppressor for protection.
Power surges are not covered under the
warranty.
1.3 PRECAUTIONS
Avoid mounting the transmitter in the im-
mediate vicinity of telephones, exchanges or
computer equipment. A few feet can make a
world of difference in avoiding interference
from the radio frequency generated by the
transmitter.
The performance of your system will be
affected by: foil backed wallboard, metal mesh,
wire-reinforced glass, metal sheeting, large
mirrors, suspended ceilings, elevator shafts,
etc. These can all reflect and thereby reduce the
signaling capability of the transmitter. A little
forethought prior to installation, coupled with a
few tests, will avoid most problems.
BNC Connector
