MM30-W
Doc. N° MO-0117-ING
Rev.
1
Pag.
3
of
29
Copyright - 2010 - Microener
1. General utilization and commissioning directions
Always make reference to the specific description of the product and to the
Manufacturer's instruction.
Carefully observe the following warnings.
1.1 STORAGE AND TRANSPORTATION,
must comply with the environmental conditions stated on the product's instruction or by the
applicable IEC standards.
1.2 INSTALLATION,
must be properly made and in compliance with the operational ambient conditions stated by
the Manufacturer.
1.3 ELECTRICAL CONNECTION,
must be made strictly according to the wiring diagram supplied with the Product, to its electrical
characteristics and in compliance with the applicable standards particularly with reference to
human safety.
1.4 MEASURING INPUTS AND POWER SUPPLY,
carefully check that the value of input quantities and power supply voltage are proper and within
the permissible variation limits.
1.5 OUTPUTS LOADING,
must be compatible with their declared performance.
1.6 PROTECTION EARTHING
When earthing is required, carefully check its effectiveness.
1.7 SETTING AND CALIBRATION
Carefully check the proper setting of the different functions according to the configuration of the
protected system, the safety regulations and the co-ordination with other equipment.
1.8 SAFETY PROTECTION
Carefully check that all safety means are correctly mounted, apply proper seals where
required and periodically check their integrity.
1.9 HANDLING
Notwithstanding the highest practicable protection means used in designing M.S. electronic
circuits, the electronic components and semiconductor devices mounted on the modules can be
seriously damaged by electrostatic voltage discharge which can be experienced when handling
the modules.
The damage caused by electrostatic discharge may not be immediately apparent but the design
reliability and the long life of the product will have been reduced. The electronic circuits reduced
by M.S. are completely safe from electrostatic discharge (8 KV IEC 255.22.2) when housed in
their case; withdrawing the modules without proper cautions expose them to the risk of damage.
