Microcom LDS II, Programming Manual

Page: 62 / 121

Printer Commands Chapter 2
46 LDSII Programming Guide - 880015-0123
starting edge of the media is aligned to the print head reducing media waste. This
command requires that the printer is equipped with an LPD and that it has been selected
using the “^D508)” command.
0 Disable
1 Enable
2.6.5 ^D726)n (Enable Auto ACK/NAK)
This command enables the automatic acknowledgement after each command. With this
command enabled, the printer automatically issues the command ACK (Human readable
descriptive text if in verbose mode, the >OK< response if in text mode, or 0x06 if in byte
mode) after a successful command. If a command was not successful, the appropriate error
response or NAK would be generated automatically. The responses are sent automatically
and do not require sending either the serialize
d “^D327)1” command or the immediate ^E
enquiry command. Refer to section 6.2 for additional information regarding the possible
enquiry responses.
0 Disable
1 Enable
2.6.6 ^D727)n (Enable Auto Error Reporting)
The “^D727)” command automatically reports halting errors immediately upon recognition of
the error condition when enabled.
The “^D550)” commands configuration determines if the
error is reported as text or as a byte code. This command automatically reports the error
and does not
require sending either the serialized “^D327)1” command or the immediate ^E
enquiry command.
0 Disable
1 Enable
2.6.7 ^D735)n (Enable Immediate Graphic Printing)
This command enables the immediate printing of any 1-bit (monochrome) BMP file that is
received by the printer. The printer places the graphic at dot one or the lower left corner of
the media as viewed from the front of the printer. The media size is based either on the last
received script or the persistent media layout ^D63x commands if a script has not yet been
executed.
0 Disable
1 Enable
2.6.8 ^D736)n (Enable Immediate Graphic Centering)
The “^D736)” command is used to laterally center immediate graphics based on the
configured print head size.
0 Disable
1 Enable