Microcom LDS II, Programming Manual

Page: 20 / 121

Designing Using LDSII Chapter 1
4 LDSII Programming Guide - 880015-0123
^J Line Feed : Represents a Line Feed (LF) character or 0x0A.
^K
Print Test Label : Causes the printer to print a test pattern consisting of diagonal
lines used to test the condition of the dots on the print head.
^L Form Feed : Scrolls one label out of the printer using the previous formats layout.
^M
Carriage Return : Represents a Carriage Return (CR) character or 0x0D.
^O
Top-of-Form (TOF) : Instructs the printer to perform a TOF operation which uses the
Label Present Detector (LPD) in order to retract the media to the proper alignment in
regards to the print head.
^P Print : Causes the printer to print. Note: If no label scripts are loaded or stored in the
printer’s memory, the printer will not print a label until a script is processed.
^Q Send Data : Instructs the printer to send data or resume sending data (XON).
^R Reset Printer : Instructs the printer to perform a reset through software that
duplicates a hard reset. Issuing the ^R causes the reset to occur immediately,
bypassing commands sent but not yet processed. The ^D390)0 command is a
queued or serialized version of the ^R and should be used if a reset condition is
desired programmatically.
^S Stop Sending Data : Instructs the printer to stop sending data (XOFF).
^U List Selections : Causes the printer to list the current configured selections of the
printer through an active communications port.
^V
List Settings : Causes the printer to list the current configured settings of the printer
through an active communications port.
^W List Statistics : Causes the printer to list the current statistics of the printer through
an active communications port.
^X Toggle Pause : Pauses the printer if printing, resumes if the printer is currently
paused.
^Y List Enablements : Causes the printer to list the current configured enablements of
the printer through an active communications port.
^Z End Script : Marks the end of a script file.
^] Cancel All Jobs : Causes all jobs currently queued to be deleted returning the printer
to its idle state. Refer to the ^D330 command.