Chapter 5
Printer Commands
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual
47
^A
^D
Command
24
Change SW4:
Change software dip switch #4. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.)
Not Used
******.))
Not Used
*****.)))
Not Used
****.))))
1=Pass ASCII over 7F, 0=Less than 80 only
***.)))))
1=Auto-size on Power-up Enable, 0=Disable
**.))))))
1=Blow-hole Stock Enable, 0=Disable
*.)))))))
1=2" Epson® Emulation Enable, 0=Disable
.))))))))
1=4" Epson® Emulation Enable, 0=Disable
Position:
1
4" Epson® Similar Emulation:
When set, the printer operates similar to an
Epson® printer with an 80 column format. This parameter enables the emulation
on printer power-up (Also see the ^A1^D38 command in section 5.3).
2
2" Epson® Similar Emulation:
Same as position 2, but prints in a 40 column
format. (Also see the ^A2^D38 command in section 5.3.)
3
Blow-hole Stock:
Enable this position when using blow-hole or cut-slot stock:
Stock that uses a hole instead of a gap to separate labels.
4
Auto-size on power-up:
When enabled, the printer automatically sizes the label
stock when turned on. The printer then uses these header values for all
subsequent label formats. See the ^D39 command in section 5.3 for more
information on auto-sizing.
5
Pass ASCII Text Over 7F:
If set to 1, the printer will process characters over 7F
hex.
6
European Configuration
7
European Configuration
8
European Configuration
Summary of Contents for 470
Page 6: ... 470 Operators Manual ...
Page 8: ... 470 Operators Manual ...
Page 10: ... 470 Operators Manual 2 ...
