Microcom 438TC, Operator'S Manual

Page: 227 / 242

13-14 438TC Operator’s Manual - 880050-0100
^A ^D COMMAND
X 94 Set Slice Buffer Size: Sets the size of the slice buffer memory that is used by
the printer to generate images to be printed. If the slice buffer memory size is
set to low, the printer may start printing and then stop to process additional
slices before starting again.
2 88Kbytes
3 192Kbytes
4 256Kbytes
5 320KBytes
6 384KBytes
XX 95 Load Advance/Retract Distance: Used in conjunction with cutter and
dispense command. The ^Axx specifies the amount to advance after printing
and then retract to dot row. The count is given in dot increments.
XX 96 Load Advance Delay: The ^Axx specifies the amount of delay, in
Milliseconds, the printer waits before retracting to dot row in cutter and
dispense modes.
X 97 Tag/Tear Dispense Mode:
0 Disables Tag/Tear Mode
1 Advance after every label.
2 Advance after copies count.
3 Advance when idle.
X 98 Peel-n-Dispense Mode:
0 Disable Peel-n-Dispense
1 Enable Peel-n-Dispense
X 99 Cutter Control: This command enables the volatile full and/or partial cut
operation. This command works in conjunction with the ^D102 and ^D103 Cut
Interval commands. The ^D95 command is also used with the ^D99 command
to adjust the advance distance to the cutter blades and then retract to the
home position (dot row one).
0 Disable Cutter operation.
1 Enable Full Cut.
2 Enable Partial Cut.
3 Enable Full and Partial Cut.
100 Clear User RAM: This command clears all the downloaded fonts and graphics
that have been stored in RAM.
101 Send User RAM Available: The printer will send the number of free or
available bytes to the serial port (i.e. >192480<). Use the D119 command for
additional reporting.