DM160232 Serial Memory Single-Wire Evaluation Kit User’s Guide
2018 Microchip Technology Inc.
DS20005939A-page 29
Once all the input data has been input, press the
WRITE
button to start the write
operation. A status message is included at the bottom of the window to notify the user
that the write operation is complete by displaying “Successful”.
Once the entire write operation is complete, the user can close the window by pressing
the red button (
) in the top right-hand corner of the pop-up window or pressing the
Close
button. Once either is pressed, a progress bar for the Refresh feature is
displayed and the entire GUI memory array and Security register are read and the GUI
is updated accordingly.
FIGURE 3-22:
WRITE OPERATION
3.13.3
Go To Address
The Go To Address feature allows the user to jump to a specific word address in the
GUI memory array. Once the
Go To Address
button is pressed, the memory address
that was input will be highlighted in a black box in the GUI memory array.
FIGURE 3-23:
GO TO ADDRESS
Note:
Due to the construction of the Serial EEPROM devices, the write operation
is limited to the page size or boundary of the installed device. If the “Data”
field exceeds the page boundary of the installed device, the GUI will
automatically parse the data into the correct page size and perform multiple
write operations until the entire data field has been written to the Serial
EEPROM.
Note:
The Go To Address feature does not work for the GUI Security register and
only works for addresses within the GUI memory array.
Close button
