2018 Microchip Technology Inc.
DS20005939A-page 11
DM160232 SERIAL MEMORY
SINGLE-WIRE EVALUATION KIT
USER’S GUIDE
Chapter 2. Installation and Operation
2.1
INTRODUCTION
Setup for the Serial Memory Single-Wire Evaluation Kit is straightforward. To start, both
the USB Base Board driver and the SWI Graphical User Interface (GUI) will need to be
downloaded and installed on the user’s PC. Once both are installed, the user should
perform a simple hardware setup sequence. Once completed, simply plug in the USB
Base Board to an available USB port on the user’s PC and launch the SWI GUI.
2.2
INSTALLING THE USB BASE BOARD DRIVER
The following steps are needed to successfully install the USB Base Board driver:
1.
Go to
http://www.microchip.com/DM160232
to download the USB Base Board
driver.
2.
Navigate to Documentation and Software and select the
USB Base Board Driver
.
3.
Download and open the setup file indicated below.
driver-atmel-bundle-7.0.888.exe
4.
If the Open File – Security Warning pops up, press the
Run
button.
5.
Once prompted, read the license terms and conditions. When ready, click the
checkbox and press the
Install
button (
).
FIGURE 2-1:
LICENSE TERMS AND CONDITIONS
WARNING
Read the DM160232 Serial Memory Single-Wire Evaluation Kit User’s Guide
(this document) fully before proceeding to evaluation kit setup.
Note:
If prompted, allow the program to make changes to your PC.
“I Agree” checkbox
Install
button
