10.1.
Mount a jumper on pin1 of J404 and J405.
10.2.
Mount a jumper on pin2 of J404 and J405.
10.3.
Mount a jumper on pin3 of J404 and J405.
10.4.
Mount a jumper on pin4 of J404 and J405.
10.5.
Mount a jumper on pin5 of J404 and J405.
10.6.
Open pin6 of J404 and J405.
10.7.
Open pin7 of J404 and J405.
11. Put the S400 switch to PIC32_MCLR position.
12. Put the SW300 switch to OFF position.
Note:
In order to perform the following demo, the user must flash the Host mode firmware into the BM83 module as
well as PIC32 MCU, as illustrated in the preceding sections.
12.1
Host MCU Mode Quick Demo
Perform the following steps to stream audio using the BM83 module in Host MCU mode.
1.
Connect the speakers to the STA369BW Audio Daughter Board at CN1 and CN2.
Figure 12-1. Speakers Connected to the STA369BW Audio Daughter Board
2.
The SW200 switch is set to 5V_USB position as shown in the following figure.
Figure 12-2. SW200 Switch Position
BM83 EVB
Appendix F: Hardware Setup for Application Dem...
©
2019 Microchip Technology Inc.
User Guide
DS50002902A-page 64
