11
Chapter 3
First-time Operation/Installation
The smartphone setting on the Bluetooth must be on. If it is off, change to on. When it
was off, see the troubleshooting in Chapter 11.
Connect a provided AC/DC power adapter to proper AC power input and connect the input
power connector to a power input jack of VM10a.
Turn on the power switch of VM10a confirm that green LED on the front panel of VM10a is on.
Note that the LED continuously blinks when VM10a and smartphone are connected via the
wireless standard.
Open VM10a app on the smartphone.
After few seconds, the screen will show very similar like the following:
Received: VM10_D2D9
The device ID does not match with received device ID.
Enter the correct 4-digit Device ID after “_” above
In the text field shown ‘D2D9’.
Close and reopen this app.
If you don’t see the above display, see the Chapter 11 Troubleshooting.
Enter the same 4-digit code like D2D9 in the text field, and close the app, and enter the app.
When your entry matches with the 4-digit code programmed in the VM10a, you will see the
following message:
Received: VM10_D2D9
The device ID matches with received Device ID.
Few seconds later you will see Go/Run in the upper left corner.