9
Wine Saver HOME has been designed for simple set-up and
ease of operation. If you are having a problem with your
system, the following suggestions will likely guide you to a
solution.
WINE SAVER HOME TROUBLESHOOTING GUIDE
Some taps are flowing wine and others are not:
Simply disconnect the Quick Connect coupler and
reinstall, making sure the coupler is properly seated.
■
Always preserve a full bottle of wine.
Preserving a previously opened bottle of wine that
is not full may result in decreased performance from
your system. Always begin preserving with a full bottle.
■
No wine is flowing from any of the Taps:
Make sure WSH Argon Gas cylinder has been completely
threaded in and is completely seated, or replace WSH Argon
Gas cylinder as it may be empty.
■
You cannot get wine to flow after the above
troubleshooting steps.
Please contact Wine Saver HOME at 610-435-5240 or
toll free at 877-601-9463 for further assistance.
■
Excess wine is remaining at the bottom of the bottle
after service:
Disconnect the Quick Connect coupler, take Tap Head /
Draw Stem assembly out of bottle neck, and adjust the
Draw Stem so that it is sitting on the bottom of the
wine bottle. (Refer to Page 3)
■
After using for some time, you notice you are not
getting 12 to 15 bottles (approximately) of wine per
WSH Argon Gas cylinder:
1. Disconnect all Quick Connect couplers.
2. Remove the Tap Head / Draw Stem assemblies.
3. Soak assemblies in hot water for a few seconds.
Remove one Tap Head at a time and spread out the
bottle seal fins to their original state.
(fins should be perpendicular to body of Tap Head)
4. Replace Tap Head / Draw Stem assemblies and
re-connect Quick Connect couplers.
■
Note: Always disconnect Quick Connect couplers
before changing bottles.
Note: There may be a slight amount of wine remaining in
the Tap Head nozzle after pouring. This is common with all
spigot based systems and is part of normal operation.
Note: Wine Saver HOME is equipped with a patented
regulator assembly with a relief valve designed for safety.
If you attempt to remove a cylinder that still has gas in it,
you will hear a pressure relief puff or whistle.
Warranty Note: Wine Saver HOME is designed specifically
for use with WSH Argon Gas as its preservative, use of any
other preservative will void the manufacturers warranty.
Summary of Contents for Wine Saver HOME
Page 1: ...OPERATIONS MANUAL...
