- 14
5-
Turn on the vacuum and using the tubes and wand head desired
begin to suction up the wet spill.
6-
The tank hold approximately 3 gallons of liquid. Note: see Fig 2.
There is a ball cock located inside the lower frame of the head
assembly. As water is suctioned and fills the tank, it will rise
with the water level inside the tank. As it approaches “full”, it
will cut off suction to the motor and the motor will be begin to
struggle and not suck up any more liquid. Move the switch to
“off” immediately.
7-
Remove the head from the tank and set it aside out of harms
way.
8-
Dump the contents of the tank in an appropriate place.
9-
Re-attach the head assembly onto the now empty tank and
continue until clean up is complete.
10-
After use, allow the tank to dry without the head assembly on
it. Once dry, re-install the filter and place the head back onto
the tank.
Summary of Contents for 90533
Page 3: ... 2 Parts Identification Fig 1 ...
Page 5: ... 4 Production Standard Safety Notice ...
Page 19: ... 18 ...
