Page 55
Ethernet Interface
IF1032/ETH
Start
,
Stop
Use these buttons to start or stop the display of measured data.
Save
Stores the measured values after the measurement was stopped. The measured
values are stored with a dot as decimal mark if the language is set to English,
otherwise a comma is used.
i
Only a limited number of measured values can be stored (about 50,000).
The oldest values will be overwritten when more values are captured.
Show
Specifies which channels are displayed in the diagram.
Autozero
Sets the selected channel to zero, e.g. for performing differential measurements.
Measuring data
display
The measuring data display consists of two parts. The lower part (Overview)
shows the last 30 seconds of the measurement. The dark-shaded area defines the
view (the time period) of the upper diagram. This area can be moved or resized
by using the mouse with left button down. The upper diagram can be resized in
the same way. The + and - buttons change the view in fixed steps. The text field
Time shows the current displayed time period. It also allows to manually change
this period. The view can be reset to default settings with a double click into the
upper diagram or a click onto the %-button. The y-axis can be scaled manually or
automatically.
i
During a continuous display the shown time period is limited to 10 seconds.
When moving the view during continuous display the diagram stops. The
incoming data will be buffered. Moving the view to the right hand end of the
lower diagram or resetting the view forces the diagram to start continuous
display again.
Always at least one channel must be chosen for display!
Summary of Contents for IF1032/ETH
Page 1: ...Instruction Manual IF1032 ETH...
Page 79: ......
