MCS-THERMOSTAT
REVISION 1.5
16
11. Main Menu Settings
CLICK ON MENU TO SEE THE SCREENS BELOW
AUTHORIZATION PASSWORD LEVEL MAY BE REQUIRED
NOTE: SOME MENU SELECTIONS WILL NOT SHOW ON YOUR THERMOSTAT LCD SCREEN,
IF THEY ARE NOT SETUP IN THE CONFIGURATION FILE FOR YOUR CONTROLLER.
11.1. UNIT STATUS
Hit ‘ENTER’ shows status of thermostat.
11.2. CONFIG MENU
Hit ‘ENTER’ - Allows user to enter Config Menu to make adjustment to the thermostat.
11.3. ENTER PASSWORD
Hit ‘ENTER’ - Authorization password level for the changes to the thermostat.
11.4. UNIT STATUS (RUN/STOP)
Hit ‘ENTER’ - Allows user to ‘RUN/STOP’ the unit controlling the thermostat.
(This must be
confiured in your controller for viewing on your thermostat).
11.5. COOL SET POINT
Hit ‘ENTER’ - Allows the user to SET THE COOL SET POINT FOR THE AREA.
11.6. HEAT SET POINT
Hit ‘ENTER’ - Allows the user to SET THE HEAT SET POINT FOR THE AREA.
11.7. HUMIDITY SET POINT
Hit ‘ENTER’ - Allows the user to SET THE HUMIDITY SET POINT FOR THE AREA.
11.8. CO2 SETPOINT
Hit ‘ENTER’ - Allows the user to SET THE C02 SET POINT FOR THE AREA.
11.9. VERSION NUMBER
Hit ‘ENTER’ - Shows current version of firmware the thermostat is using.
11.10. TIME AND DATE
Hit ‘ENTER’ - Shows current time and date of unit operating thermostat.
11.11. LAST LOCKOUT ALARM
Displays abbreviations for the last three alarms on the first screen before flashing to a second
screen displaying the time/date of respective alarm.
For example, in a displayed ‘LO DIS PSI’ alarm listing, the user interface would switch to a
screen displaying ‘Jan 31 12:10’ as the occurrence time for the first ‘LO’ alarm before jumping
back to the ‘LO PSI LO’ alarm display and switching to a screen displaying ‘Feb 2 12:10’ as
the occurrence time for the second ‘PSI’ alarm.
11.12. LOCKOUT RESET
Hit ‘ENTER’ - Allows used to reset lockout if authorized
.