9
©2022 Micro-Air Corp
March 21, 2022, revision 1.0
Operating the Thermostat
Main Screen
This screen is where most time is spent using the
thermostat. This screen allows you to set and
monitor the desired operation of the thermostat
and is shown in
(1) Inside temperature
This is the temperature reading for the space that
the thermostat is trying to temper, determined by a
local sensor. “Inside” means it is using a sensor
inside the thermostat.
“Inside(R)” indicates that a
Remote sensor is in use and connected to the
green/white wires on the back of the thermostat.
(2) Local Weather
This icon indicates the local weather at the last time
weather information was received. Tap the icon for
more detailed weather information. See the
(3) Status Tray
Various icons may be here to indicate active operations.
The Wi-Fi
indicator shows the state of the thermostat’s
Wi-Fi connection. No icon means
no connection to an internet enabling device. Red means it is connected to an internet
enabling device but does not have internet. Green means it is connected to the internet.
The number of bars indicate strength. See the
Connecting to a New Wi-Fi Network
more details.
The Furnace icon here means that the heat mode is in Active Gas Changeover. See section
The Schedule icon here means that the created schedule is active and will change
operation on that schedule. This is turned on and off in the Settings screens. See section
(4) Status Message
Various messages may be shown here to indicate active operations. See the
potential messages and their meanings.
(5) Temperature Set Point Adjust
Raise and lower the temperature set-point using the red and blue arrows. This sets the desired
temperature for the space based on the operating mode. All modes are listed in the
section.
Wi-Fi Indicator
Gas Changeover
Active
Schedule Active
Figure 1
–
Main Screen
