19
Disassembly of the Motor
Housing
1. Hold the Motor Housing in a
vice using Copper Jaws. Clamp
against the front and rear of the
Housing
(see figure 19.1)
.
NOTICE:
Never clamp on the
sides of the Housing as damage
is likely to occur.
2. Using a 1" box wrench,
remove the Inlet Bushing
(750SS-07). Remove the O-ring
(750SS-08) from the Inlet
Bushing and discard. Remove
the Air Strainer Screen (750SS-
06), the Throttle Valve Spring
(750SS-05) and the Throttle Valve
(750SS-04) from the Housing and
set aside.
3. To remove the Throttle Valve
Seat (750SS-02), slide a flat hook
under the seat and firmly pull up
(see figure 19.2).
4. Using internal snap ring
pliers, collapse and remove
the Retaining Ring (750SS-20).
Remove the Exhaust Deflector
(750SS-11) using a pair of needle
nose pliers. Remove the Muffler
(750SS-09) from the Housing
and discard. Always use a new
Muffler for reassembly.
Figure 19.1
Always clamp the Motor Housing against
the front and rear of the Housing. Never
clamp against the sides of the housing as
damage can easily occur.
Figure 19.2
Slide a flat hook under the Throttle Seat and
firmly pull up to dislodge it from the Motor
Housing.
Disassembly
Summary of Contents for 750SS Series
Page 27: ...27 Notes...