Propane Patio Heater Manual
11
7. Fill the base with sand as a counter weight.
8. Install cylinder guard to the base.
9.
Connect gas line to LP cylinder.
Attach Gas Hose
to the Regulator with 3/8” open end wrench and
adjustable wrench. Attach Regulator to LP cylinder.
Tighten securely, then move LP cylinder to the plate
of the Base assembly.
NOTE: All leak test procedures should be com-
pleted before use.
10.
Check for leaks.
All factory connections of your Patio
Heater have been checked. To check the connections
of the Gas Hose / Regulator / LP cylinder:
a. Make leak test solution by mixing 1 part liquid dish
soap and 3 parts water.
b. Spoon several drops (or use a squirt bottle) of
the solution onto the Gas Hose/Regulator or the
Regulator/LP cylinder connection
c. Inspect the connections and look for bubbles.
d. If no bubbles appear, the connection is safe.
Do not use a flame to test for leaks!.
e. If bubbles appear, then there is a leak. Loosen and re-tighten the connection where bubbles are present.
11.
Close access door on base cover.
12.
Disconnect LP cylinder when storing or transporting.
Turn off heater and turn off valve on LP cylinder.
Disconnect the Regulator and remove LP cylinder.
NOTE: Turn off valve on gas cylinder when heater is not in use.
ASSEMBLY FOR MH-0040-PM10 (AFTER SERIAL # 5450 1014 00001)
7.
Fill the sand into
the hole untill full.
Tighten
8.
9.
